Using the CPOL3 with one of our test devices, such as the CPC 100, COMPANO 100, CMC 353, or CMC 356, provides a wide range of wiring and polarity testing options.
The new functions of the CPOL3 offer even greater testing flexibility.
- Displays True RMS voltage and polarity
- “Oscilloscope” mode displays signal waveform
- Low input impedance mode (LoZ) suppresses coupled signals
By measuring the voltage and displaying the signals, polarity checks can be combined with additional information to detect the most common wiring errors. This approach serves as a foundation for several valuable applications and opens the door to various alternative testing methods.
Primary Injection Testing – The polarity of a current transformer can be verified by injecting a sawtooth signal into the primary side using a CPC 100, a CMC test set, or a COMPANO 100. The polarity on the secondary side can then be checked with the CPOL3.
Secondary Injection Testing – After verifying the polarity of the current transformer, you can inject the signal on the secondary side. This allows you to test the polarity of the terminals all the way to the protective relay using lower currents. If you use the nominal current for the test, you can even determine the load directly from the measured voltage.
Testing the wiring with voltage – The CPOL3 has such high measurement sensitivity that the terminals can act as a shunt to capture the signal for polarity measurement, with the nominal current usually being sufficient. To achieve this, the polarity is measured at various points along the current path, with the voltage decreasing towards the load. Since terminal points are generally easy to access, this method allows all terminal points to be checked for the correct sequence.
Testing with a current clamp – The test signal is typically read and evaluated directly with the CPOL3, which is simple, safe, and fast. However, in some cases, interference from other phases can occur, and direct measurement is less suitable for self-powered relays. In such situations, testing with a current clamp is recommended. The only drawback is that accessing the secondary wiring with the current clamp can sometimes be challenging.
Testing with low input impedance – Coupling capacitances of 1 nF or more can occur in long parallel lines within the secondary wiring. The load in a voltage transformer circuit’s relay or meter typically has very high resistance. Together with the coupling capacitance, this forms a capacitive-resistive voltage divider, creating coupling between the phase under test and other phases. CPOL3 addresses this issue with a low input impedance mode (LoZ) that effectively suppresses such effects.
Testing test switches and test plugs – Test switches or plugs are crucial for ensuring safety when replacing or testing meters and relays in current transformer circuits. The COMPANO 100 features an “interrupt trigger” function that allows for safe test current injection and polarity testing when used with the CPOL3. If a test switch is present, it can be activated multiple times (The test switch might be triggered during the test current’s zero crossing; however, this is rare). If CPOL3 no longer indicates polarity, it suggests that COMPANO 100 has detected an interruption and halted the output. The COMPANO 100 will then display the duration of the interruption, signaling a potential issue with the test switch, which must operate without disruption.
Original Article: https://www.omicronenergy.com/en/news/coverstory/useful-knowledge-tips-for-wiring-and-polarity-tests-with-cpol3/
Additional information: CPOL3: With new features for even more effective wiring tests and polarity checks
